Source:Hearing Research
Author(s): Ivo Dobrev, Jae Hoon Sim, Stefan Stenfelt, Sebastian Ihrle, Rahel Gerig, Flurin Pfiffner, Albrecht Eiber, Alexander M. Huber, Christof Röösli
BackgroundBone conduction (BC) is an alternative to air conduction to stimulate the inner ear. In general, the stimulation for BC occurs on a specific location directly on the skull bone or through the skin covering the skull bone. The stimulation propagates to the ipsilateral and contralateral cochlea, mainly via the skull bone and possibly via other skull contents. This study aims to investigate the wave propagation on the surface of the skull bone during BC stimulation at the forehead and at ipsilateral mastoid.MethodsMeasurements were performed in five human cadaveric whole heads. The electro-magnetic transducer from a BCHA (bone conducting hearing aid), a Baha® Cordelle II transducer in particular, was attached to a percutaneously implanted screw or positioned with a 5-Newton steel headband at the mastoid and forehead. The Baha transducer was driven directly with single tone signals in the frequency range of 0.25–8 kHz, while skull bone vibrations were measured at multiple points on the skull using a scanning laser Doppler vibrometer (SLDV) system and a 3D LDV system. The 3D velocity components, defined by the 3D LDV measurement coordinate system, have been transformed into tangent (in-plane) and normal (out-of-plane) components in a local intrinsic coordinate system at each measurement point, which is based on the cadaver head's shape, estimated by the spatial locations of all measurement points.ResultsRigid-body-like motion was dominant at low frequencies below 1 kHz, and clear transverse traveling waves were observed at high frequencies above 2 kHz for both measurement systems. The surface waves propagation speeds were approximately 450 m/s at 8 kHz, corresponding trans-cranial time interval of 0.4 ms. The 3D velocity measurements confirmed the complex space and frequency dependent response of the cadaver heads indicated by the 1D data from the SLDV system. Comparison between the tangent and normal motion components, extracted by transforming the 3D velocity components into a local coordinate system, indicates that the normal component, with spatially varying phase, is dominant above 2 kHz, consistent with local bending vibration modes and traveling surface waves.ConclusionBoth SLDV and 3D LDV data indicate that sound transmission in the skull bone causes rigid-body-like motion at low frequencies whereas transverse deformations and travelling waves were observed above 2 kHz, with propagation speeds of approximately of 450 m/s at 8 kHz.
from #Audiology via xlomafota13 on Inoreader http://ift.tt/2xqgQ1s
via IFTTT
