Body regional heat pain thresholds using the method of limit and level: a comparative study

Abstract

Purpose

The purpose of this study was to compare cutaneous heat pain thresholds using the method of limit and level.

Methods

Sixteen young males (23.2 ± 3.2 year, 174.9 ± 4.9 cm, and 70.1 ± 8.6 kg) participated in this study. The thermode temperature increased at a constant rate of 0.1 °C s⁻¹ from 33 °C for the method of limit, whereas the method of level consisted of 3 s heat pulses increasing from 44 °C to 50 °C in 100 s separated by 5 s intervals. All measurements were conducted on 14 body regions (the forehead, neck, chest, abdomen, upper back, upper arm, forearm, waist, hand, palm, thigh, calf, foot, and sole) in 28 °C, 35% relative humidity.

Results

The results are as follows. Heat pain thresholds were on average 3.2 ± 2.1 °C higher for the method of level than for the method of limit (P < 0.05). Second, the correlation coefficient between values by two methods was 0.819 (P < 0.01). Third, lower body regions (thigh, calf, and sole) had higher heat pain thresholds than upper body regions (chest) by the method of level only (P < 0.05). Fourth, body regional subcutaneous fat thickness showed no relationship with heat pain thresholds except the upper arm.

Conclusion

These results indicated that cutaneous heat pain thresholds vary based on the type of heat stimuli and body regions. The method of limit could be applied for predicting accumulated thermal pain starting from moderate heat, whereas the method of level may be applicable for predicting acute heat pain to flames or high heat.

http://bit.ly/2VNIfWO